6
Connect the HORIZONTAL WIRING CABLES To the inside vertical assembly and through all
other tubing, as the unit is assembled. Sometimes “fishing” the wiring cable through the tubing
can be a challenge due to the screws, etc. We have found that a “fish tape” made from a scrap
section of tape does a great job. Just attach one end of the harness to a 10-12’ length of tape with
electrical tape and push the tape through the tube. The cable can then be easily pulled through
using the tape to push the tape through the tube. The cable can then be easily pulled through using
the tape to pull the cable. Attach the tubing to the INSIDE VERTICAL UNIT using two of the
extruded internal SPLICE PLATES². Be careful when running screws into the tubing not to nick
or cut any of the wires.
The
FORMED RADIUS
needs to be attached to the
INSIDE VERTICAL EXTENSION
using the
extruded internal
SPLICE PLATES³.
CAUTION:
The
FORMED RADII
are not designed to be cut. They were designed to be
used as is. Any modifications to this component will void the warranty and will likely yield
less than acceptable operation.
The
CUSTOMER VERTICAL UNIT
is completely assembled and designed for installation at a site
with no elevation difference from the lane to the island. Measure the distance from the lane to the
island and cut this amount off of the bottom of the
CUSTOMER VERTICAL UNIT
. It mounts to
the island with a
CUSTOMER BASE UNIT
. The
CUSTOMER BASE UNIT
mounts to the island
via two 3/8" holes (Note: base unit to island fasteners not provided) and to the
CUSTOMER
VERTICAL TUBING
via two self-drilling screws
4
. The
CUSTOMER VERTICAL UNIT
is 120"
tall. It needs to be cut to length which will allow the
HORIZONTAL TUBING
to be plumb
horizontally after the
FORMED RADIUS
is attached to it. Be sure to deburr and chamfer each end
of the tubing
5
before proceeding.
CAUTION:
When cutting off the top of the customer unit, make sure that the vertical cable
from the customer unit is pulled back down the customer tube to prevent cutting the cable.
_______________________
2
Fig. 2
3
Fig. 2
4
Fig. 3
5
Fig. 1
