Storage conditions
Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06
Document No.: 5.02056.01A
Baumüller Nürnberg Electronic GmbH & Co. KG
42
11.4
m
Suitable packaging for the CANsync-Master option module; if possible, the original
packaging.
m
Cover plate to cover the slot.
m
Suitable tools for pulling out the board (e.g.pointed electronic pliers)
Carry out dismantling in the following sequence:
1
Deenergize the b maXX 4400 basic unit and secure it from unintentional switch-on.
2
Wait ten minutes (the capacitors discharge).
3
Open the switching cabinet.
4
Remove the b maXX 4400 basic unit's cover.
5
Remove the male connectors from the sockets.
6
Turn the spagnolet locks above and below the CANsync-Master option module's front
panel slot by 90° (in the horizontal position, they are unlocked).
7
Pull the CANsync-Master option module by the handle forwards out of the b maXX ba-
sic unit.
8
Place the module in the prepared packaging – when doing this, only touch the plug-in
module by the handle.
9
Now fit a cover (or a new CANsync-Master option module for b maXX PLC) in the open
slot (the handle must be pointing toward the right-hand side of the unit).
10
Turn the spagnolet locks by 90° (in the vertical position the locks are fastened).
11
Remount the cover on the unit.
12
Close the switching cabinet.
13
Document in writing dismantling (or replacing) the CANsync-Master option module.
You can now switch the unit back on. If you want to dispose of the module, refer to chapter
from page 43 onward for more information.
11.4 Storage conditions
Store the CANsync-Master option module for b maXX PLC in suitable packaging accord-
ing to the storage conditions in
11.5 Recommissioning
If you want to recommission the CANsync-Master option module for b maXX PLC, ob-
serve the storage conditions in
from page 53 onward. Then, carry out
commissioning again.
CAUTION
The following
may occur
,
if you do not observe this caution information:
m
property damage.
Danger from:
electrostatic discharge.
The electronic components on the PCB can be dam-
aged or destroyed if you touch them with your hands.
Only touch the CANsync-Master option module by the handle on the front panel.