13
3)
Using a drill bit with a diameter of 6mm, make holes in the wall
on the points you have just marked.
4)
Insert the rawlplugs in the holes and then screw the support
(upper) screws halfway in.
5)
Hook the hood onto the screws and secure it from the inside,
tightening the support and anchoring screws.
6)
Connect the discharge pipe to the collar ‘A’ (see Figure 3, below).
7)
Replace the grease filter grilles.
FITTING THE HOOD ONTO A KITCHEN WALL UNIT – Extraction Mode
1)
Remove the metal grease filter
grilles (see page 9)
2)
If using the hood in extraction
mode, make a hole with a
diameter of 130 mm in the
kitchen unit, aligned with the
discharge hole of the hood. If
necessary, make a hole in the wall
to insert the power cable.
3)
Rest the hood on the wall unit
and mark the points for the
support holes ‘F’ (see Figure 5,
below, at right).
4)
Screw the four screws
provided halfway into the
marks you made.
5)
Hook the cooker hood onto
the support screws and screw
them in.
6)
Connect the ducting to the
collar (spigot) ‘A’ (Fig. 3).
7)
Replace the anti-grease filter
grilles.
INSTALLATION INSTRUCTIONS – Setting up your Hood