Installing your new cooker
Kick Panel
Stability
Bolt
Stability
Bolt Bracket
Stability Bolt
Hole in Floor
Rear control models
Installation Sequence
• Determine position of cooker and ant-tilt floor
bracket.
• Mark position of holes that need to be drilled into
floor.
• Drill holes with correct type drill bit suitable for floor
type.
• Securely fix the anti-tilt floor bracket to the floor with
appropriate fasteners.
• The stability bolt is fitted during production to front
of cooker, the kick panel is not fitted to ensure the
stability bolt is utilised during installation.
25mm from side of
bracket on both sides
to cupboards or walls
• Reposition the cooker back into the anti-tilt floor
bracket and then mark the position for hole in floor
to house the stability bolt.
• Pull the cooker back out and drill the bolt location
hole. Use a 10mm masonry or wood drill bit,
depending on floor type. When drilling into concrete
ensure a minimum hole depth of 30mm.
• Reposition the cooker back into the anti-tilt floor
bracket, aligning the stability bolt with the 10mm
drilled hole. Then remove tape from stability bolt
and slide the bolt through the bracket and into the
hole.
• Connect Electricity supply/gas supply but do not
turn on until installation is completed.
• Slide the cooker back into the anti-tilt floor bracket
so that rear cover rests against the rear wall. Then
check the height and level of the cooker.
If required, pull the cooker back out and adjust the
leveling feet as required.
Baumatic 540mm Upright Cooker INSTALLING YOUR NEW COOKER 25
The installation of splash back
• To fit splash back, align the 2 tabs of the splash
back with the corresponding holes in the hob and
push downwards.
• Fit screws.
Rear control models
Locating the cooker
Study the diagrams below to be sure of the dimensions
required to locate the cooker safely. Make sure that
the top of the cooker is at least 10mm higher than the
level of the bench tops. Unscrew leveling legs by about
10mm to give clearance to the anti-tilt floor bracket.
The appliance has been designed to fit in a 550mm
wide gap in kitchen cabinets. The cooker may also be
installed at the end of a line of benches or with a free
space on either side.
NOTE: To ensure cooker stability, both the anti-tilt
floor bracket and anti-movement / stability bolt (this
is fitted to the cooker during assembly and located
behind the kick panel) must be installed on all
cookers (electric and gas).
Front control models
Installing your new cooker
24 Baumatic 540mm Upright Cooker INSTALLING YOUR NEW COOKER