Installing the appliance
o
Cut a hole in the worktop that corresponds with the drawing
shown above.
o
If the hob is being installed without an oven below it, a
separator panel must be placed between the bottom of the hob
and the housing below it, at a minimum distance of 10 mm.
o
If the hob is being installed with an oven below it, place a
separator panel at a minimum distance of 15 mm and follow the
oven manufacturer’s instructions, ensuring that sufficient
aeration is provided.
o
The heat produced by the oven, measured on the right side of
the bottom of the hob, must be lower than 60°C otherwise the
heat could damage the touch control panel.
o
IMPORTANT: You must observe the ventilation requirements
shown in the drawing below.
25
Summary of Contents for BKF24ID
