Baumatic BFWM1206BL, Instruction Manual

Page: 32 / 40

Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear on the control panel.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR
POWER SUPPLY.
Error code Reason Solutions
“Spin”
LED
flashes
Inlet water
overtime.
o
Open the water tap to check if
the inlet hose is squashed or
kinked.
o
Check if the filter in the inlet
valve is blocked or not.
o
Check if the water pressure is
too low.
“Rinse”
&
“Spin”
LED’s flash
Overtime of the
drainage.
o
Check if the drain pump is
blocked (see relevant section).
“Rinse” LED flashes The door has not
been closed.
o
Check if the door of the washing
machine is closed.
o
Check if the clothes are
preventing the door from closing
properly.
Any other combination
of flashing LED lights.
Other
o
Contact the Customer Care
Department.
If one of the above fault codes reappears
after following the above advice and clearing
the fault code. You should turn the washing
machine off, disconnect the appliance from
your mains supply, and then arrange for an
engineer to attend the appliance. You should
contact the Baumatic Customer Care
Department on (0118) 933 6911.
IF AN ENGINEER ATTENDS DURING THE
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED
BY THE CUSTOMER. THEN YOU MAY BE LIABLE
FOR THE COST OF THE SERVICE CALL.
32