Baumatic BFR6, Instruction Manual, Page: 13 / 28

Changing a light bulb
IMPORTANT: BEFORE ATTEMPTING TO CHANGE A
LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE
DISCONNECTED THE RANGEHOOD FROM YOUR
MAINS SUPPLY.
o
Remove the grease filter (as described on page 12).
o
Prior to touching the light bulbs ensure that they have cooled
down.
o
Find the bulb that requires replacement, you will find it located in
the light fixture which is inside the exposed section of the
canopy.
o
Disconnect the light wiring point
which is located within the hood,
(behind the grease filer).
o
Then use a screw driver remove the bulb
holders and wiring from the hood.
IMPORTANT: It is not possible to replace
the bulbs individually, it will be necessary to
obtain the bulbs, bulb holders and wiring as
a complete part. This is available from our
Spares Department.
o
Bulb type: LED lamp unit, 1.5w
o
Fit the replacement bulbs, bulb holders and wiring in the same
manner as the originals.
o
Reconnect the light wiring point.
o
IMPORTANT: Defective bulbs should be replaced immediately.
o
If the light or lights still do not work, make sure that the lamps
are fitted properly into their housings before you call for
technical assistance.
o
Refit the grease filter and close the cover screen.
13