4
INSTALLATION INSTRUCTIONS
TECHNICAL DATA
MODELS BIZ2SS
BF23SS
BF24SS
Voltage
230V 230V 230V
Current
16 29 32
Hi-light plate 1800 W
-
1
-
Hi-light plate 1200W
-
1
-
Induction plate 2200W /Booster 3000W
1
1
1
Induction plate 18000W
-
-
1
Induction plate 18000W/Booster 2800W
-
-
1
Induction plate 1400W
1
1
1
Max power W
3.6kW
6.6kW
7.2kW
Electrical cable
3x2,5 mm
2
3x2,5
mm
2
3x2,5
mm
2
1.Installation (Fig 1)
Installation is the buyer’s responsibility. The manufacturer accepts no liability for this service. Any action that
the manufacturer has to take due to an erroneous installation will not be covered by the guarantee.
The flush-mounted cook tops are designed for installation in work tops made of all kinds of material,
providing they can withstand a temperature of 100°C, and are between 25 and 40 mm thick. If the cook top is
installed in a position so that the side of a kitchen unit comes up against its left-hand or right-hand side, the
distance between the vertical panel and the edge of the cook top must always be at least 150 mm. The
distance between the back wall and the edge of the cook top must be at least 55 mm. A partition made of
insulating material (wood or the like) must be inserted between the cook top and the space below. This
partition must be at least 25 mm from the underside of the cook top tray.
Fixing the cook top to the unit (Fig 2)
The cook top is fixed to the unit by means of the brackets and accessories provided. Holes are provided in
the bottom of the tray where the tabs (A) are inserted so that you can attach the screws (C) that hold the
brackets (B) in place.
Applying the seal (Fig 3)
Important - The figure shows how the seal must be attached all around the perimeter.
This cook top has been designed for non-professional, domestic use.
2.Electric connections (Fig 4)
Check the details given on the nameplate situated on the underside of the cook top, then make sure that the
rated mains voltage and power available are suitable for its operation.
Before making the electric connections, check the efficiency of the earthing system. Earthing of the cook top
is compulsory by law. The manufacturer will accept no liability for any personal injury or damage to property
deriving from failure to comply with this requirement.
For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord.
The cord’s earthing conductor is colored yellow and green. The plug must be accessible.
If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of
at least 3 mm between the cook top and the mains.
To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access
the contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and then
close the terminal block cover again immediately.
If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than
the line conductors.
Use only rubber cable type H05RR-F.
DECLARATION OF CONFORMITY. In the parts destined to come into contact with foodstuffs, this appliance
is in accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative
Decree N° 108 of 25/01/92.
CE
Appliance conforming to the European directives 89/336/EEC, 93/68/EEC, 73/23/EEC and subsequent
revisions.
