Baumatic BAF90EG, User Manual

Page: 13 / 28

Baumatic BAF90EG 900mm Upright Oven User Manual 13
• With a slotted screwdriver turn the choking screw (see figure 14) and, while observing the flame at the same time
through the cooker porthole, evaluate the consistency of the flame so it remains on when switching quickly from
the MINIMUM to the MAXIMUM position.
• WARNING: The above-mentioned adjustment should be made only with natural gas burners, while for
those operating with liquid gas the screw must be locked at the end in a clockwise direction.
Appliance Electrical Connection
The electric connection must comply with the current legal standards and regulations.
Before making the connection, check that:
• The system electrical rating and the current outlet are adequate for the maximum power output of the appliance
(see the label applied to the bottom of the casing).
• The outlet or the system is equipped with an efficient ground connection in accordance with the current legal
standards and regulations. The manufacturer will not be responsible for the non-compliance with these instructions.
• The power cord is supplied with a 15A plug, suitable for the load indicated on the label and a standard 15A GPO.
• The power cord must be positioned so that a temperature of 75°C will not be reached at any point.
• Do not use reductions, adapters or splitters since they might cause false contacts and lead to dangerous overheating.
When the connection is made directly to the electric network:
• Use a device that ensures disconnection from the mains in which the contacts are opened to a distance that permits
complete disconnection according to the conditions for over-voltage category III.
• The ground wire must not be interrupted by the circuit-breaker.
• As an alternative, the electric connection can also be protected by a high-sensitivity residual current circuit- breaker
but this may be subject to nuisance tripping due to residual humidity in heating elements.
• It is highly recommended to attach the special green-yellow ground wire to an efficient ground system.
WARNING: If the power cord is replaced, the ground wire (yellow-green) connected to the terminal, should
be longer than the other wires by about 2 cm.
WARNING: if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
similarly qualified person in order to avoid a hazard.
Appliance Electrical Connection