Baumatic BAF90EG, User Manual

Page: 11 / 28

Baumatic BAF90EG 900mm Upright Oven User Manual 11
• Legs should be installed with the appliance close to its final destination,
as the legs are not designed for excessive force and will snap off if
too much side force is exerted on them (dragging along or angled
too much). When fitting, try to keep the appliance as close to a
horizontal position as possible. Use of a pallet jack is recommended.
If the legs are not used and the cooker is mounted onto a plinth, four
transit supports allow for clearance.
• With the legs fitted, the splash-back can be fitted.
• Follow the instructions shown in Fig. 07
Anti-tilt Device
• A chain should be fitted by the installer within 50mm of the hose connection point to prevent strain on the hose when
the cooker is pulled forward. The chain should restrict the appliance movement to no more than 80% of the hose
length. After the chain is installed, check that there is no strain on the hose or gas connections when the cooker is
pulled as far forward as the chain allows.
• The cooker is also supplied with two chains which are connected to the rear left and right of the appliance. The
chains should be connected to the wall directly behind the chains as low as possible to prevent the appliance from
tilting forward. If the appliance is installed between two cupboards, drill a hole on each side of the cupboards, pass
the chains through the holes and anchor the chains within each cupboard. Ensure the chain connections are strong
enough to support the weight of the appliance and taught to prevent it from tilting forward.
Anti-tilt Device
• WARNING: In order to prevent accidental tipping of the
appliance, for example a child climbing onto the open
oven door, the stabilising means must be installed.
Ensure the chains are correctly anchored to prevent the
appliance from tilting forward and to prevent strain on
the hose when the cooker is pulled forward.
• MAKE SURE THE ANTI-TILTING CHAINS ARE
TAUGHT WHEN ANCHORED TO PREVENT THE
APPLIANCE TILTING.