6.2 Maintenance
Maintenance Chart
General Inspection
Inspect the unit for any buildup of
contamination (dirt, stones, etc.).
Daily
Cutting Teeth
Check and replace one at a time as
necessary. The teeth on the outer edge of
the wheel wear faster and are more prone to
chipping. With average daily use expect to
replace 5 to 10 teeth per week. (See Replace
Cutting Teeth in this section.)
Every 2 hours.
Cutting Wheel Retaining Nut
Tighten to 130-140 lb-ft. (176-190 Nm) of
torque.
Only if cutting wheel is
replaced.
21
