Baumalight MX530, Operator'S Manual, Page: 27 / 32

6.5 Replace Cutting Teeth
1. Park excavator and mulcher on a level surface.
2. Lower mulcher to the ground.
3. Shut off engine and remove key.
4. Inspect cutting teeth (A) for damage and wear.
Replace individual teeth as needed.
5. Remove locknut (B) and tooth (A). Install new
tooth.
6. Tighten locknut (B) to 150 lb/ft (204 Nm) of
torque.
Note: Parts breakdown can be found on
Baumalight’s website.
www�baumalight�com
6.6 Motor Shaft Seal
To prevent hydraulic motor damage, the motor
shaft seal is designed to fail if case pressure
exceeds 100 psi (689 kPa).
If motor shaft seal (A) has failed, verify case drain
line is free flow to sump or reservoir. Also check
drain line for blockage. Correct any problems
before replacing shaft seal.
3
2
1
Order replacement seal kit from Baumalight and
follow instructions provided with kit.
Motor Shaft Seal Replacement manual can be
found at www.baumalight.com/support
Note : Parts breakdown can be found on
Baumalight’s website.
www�baumalight�com
25