Baumalight MX530, Operator'S Manual, Page: 14 / 32

^
WARNING
Pressurized fluids can penetrate the
skin�
Disconnect and lock out power source
before disconnecting and/or connecting
hydraulic hoses�
The mulcher is equipped with short hoses that
are connected to the hydraulic motor. You must
connect your excavator hoses to these hoses.
All mulcher motors except the A450 will have
pressure, return and case drain connections.
The A450 motor will not have the case drain
connection.
Identify the pressure port hose from the following
chart and connect your hoses to the mulcher
hoses. Excavator hoses must be the same size as
the mulcher hoses. Using smaller diameter hoses
will decrease hydraulic flow.
4.3 Motor Pressure
Port
A450 - Rear port (away from shaft)
B550 - A port on block (rear port on motor)
C510 - A port on block (B port on motor)
C530 - A port on block (B port on motor)
C540 - A port on block (B port on motor)
C550 - A port on block (B port on motor)
C570 - A port on block (B port on motor)
C590 - A port on block (B port on motor)
^
WARNING
Prevent serious injury or death�
Always stop engine and remove key
before leaving operators seat�
Disconnect and lock out power source
before connecting mulcher to excavator�
The brush mulcher is equipped with a universal
mounting plate (A). Weld your excavator’s
mounting plate to this plate.
Also available is an optional aftermarket plate (B)
that is designed specifically for your excavator.
4 INITIAL SETUP
4.1 Mounting Plate 4.2 Hydraulics
12