Baumalight GXM350, Operator'S Manual, Page: 18 / 24

5 SERVICE AND
MAINTENANCE
^
WARNING
Prevent serious injury or death caused
by unexpected movement:
1�
Park excavator on a level surface�
2�
Engage excavator parking brake�
3�
Disengage hydraulic drive�
4�
Shut off engine and remove key.
^
WARNING
Drilling, sawing, sanding or machining
wood products can expose you to wood
dust, a substance known to the State of
California to cause cancer�
Avoid inhaling wood dust or use a dust
mask or other safeguards for personal
protection� For more information go to
www�P65Warnings�ca�gov/wood�
^
WARNING
Wear an approved dust mask or
respirator�
Follow local, state and federal
regulations�
Each tooth can be rotated up to two times before
replacement is necessary.
1. Park excavator and grinder
on a level surface.
2. Lower grinder to the ground.
3. Shut off engine and remove
key.
5�1 Rotate Cutting Teeth
4. Inspect teeth for wear on top edge (A). Once
top edge is worn, rotate tooth so a new edge is
on top (cutting) edge.
5. Loosen locknut on tooth and rotate tooth 1/3
turn. Flat shoulder (B) on tooth will fit against
shoulder (C) on tooth holder.
6. Tighten tooth locknut to 65 lb/ft (88 Nm) of
torque.
Note:
Parts breakdown can be found on
Baumalight’s website. www.baumalight.com
16