36
Adjust the feet
Install the appliance on a level
surface, near to electrical,
water and drain connections.
If the floor is uneven, adjust
the feet (do not insert pieces of
wood, cardboard etc. under
the feet):
1.
Loosen the locknut using the
wrench provided.
2.
Adjust the height of the
foot by hand.
3.
Retighten the locknut by
turning it anti-clockwise.
Make sure that all feet are
resting correctly on the
floor and that the appliance
is perfectly level and stable
(use a spirit level).
The appliance can be installed
in an area 40 cm wide and
63 cm deep.
Note:
if you install the
machine on thick carpet, adjust
the feet to ensure that there is
sufficient space under the
machine for the air to circulate.
Connect the water inlet
hose.
1.
Carefully screw the water
inlet hose onto the tap by
hand.
2.
Make sure there are no
kinks in the hose.
3.
Check water-tightness of
tap and appliance
connections by turning the
tap completely on.
If the hose is too short, replace
it with a suitable length of
pressure resistant hose
(minimum 1000 kPa - EN 50084
approved type).
Periodically check the hose for
brittleness and cracks. Replace
if necessary.
The appliance can be
connected without a nonreturn
valve.
For Great Britain & Ireland
only (if available):
1.
Carefully screw both water
inlet hoses:
•
hot (see
A
) fill hose,
•
and cold (see
B
) fill hose.
The warm water inlet
temperature must not exceed
60° C.
A
B
