Bauknecht TRPC 86531, Instructions For Use Manual

Page: 29 / 51

21
EN
The colon on the display between
hours and minutes blinks.
The programme starts automatically,
in time to be finished at the end of the
delay period. On programme start, the
delay on the display is replaced by the
remaining programme duration.
The programme duration can be
influenced by certain factors, mainly
by the humidity level of the laundry.
For that reason, the programme
duration is recalculated and adapted
in certain programme phases. During
these phases, the display shows an
animation.
This can lead to an earlier or later
programme end than originally set
with the
Finish in
function. In that case,
the display indicates, after programme
end, that the programme has finished
earlier or later.
When selecting a delay, the original
programme duration appears again
after the maximum possible delay of
23:30 hours. To exit the settings mode
again without setting a delay, select
and confirm the default programme
duration.
To cancel the delay:
Either press
Start/Pause
to cancel
the delay. To start the selected
programme immediately, press
Start/
Pause
again.
Or press and hold
On/Off
to cancel the
complete programme setting.
SETTINGS
The following settings can be
changed:
Language:
to adapt the display
language
Key tones:
to adapt the tone when
pressing a button
Cycle end alert:
to adjust the tone
signal at the end of the programme or
switch it off completely
Display contrast:
to regulate the
contrast of the display text
Water conductivity:
to adapt to
your local water conductivity; refer
to section FIRST TIME USE for more
information.
Remember last used cycle:
to activate
or deactivate recall of the programme
which you used last when switching
on the dryer
Eco mode:
to activate or deactivate
the automatic switch-off function
after programme end
Factory settings:
to return to factory
settings
Press and hold the
Settings button
for at least 3 seconds . The display
indicates that you entered the
Settings mode.
Turn the knob to scroll through the
settings. Confirm the setting which
you want to change by pressing the
knob.
Turn the knob to adjust the setting;
confirm by pressing the knob.
Press the
Settings button
to exit. If
you do not press the Settings button,
the settings mode will be exited
automatically after about 10 seconds.