BAUKER PPS200G, Original Instruction Manual

Page: 10 / 16

EN-10
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
1. CHANGING THE SANDING PAPER
SANDING PAPER WITH HOOK & LOOP SYSTEM FIT THE SANDING PAPER (See Fig A)
The sanding papers are placed directly onto the base plate. The hole pattern in the base plate and
sanding paper must match. Then press the sanding paper onto the base plate by hand. Firmly press
the power tool with the sanding paper against a flat surface and briefly switch the power tool on. This
provides for good adhesion and prevents premature wear
Before placing on the sanding paper, free the base plate from dust/debris by lightly
tapping against it.
REMOVE THE SANDING PAPER
Simply remove the sanding paper directly.
SANDING PAPER WITHOUT HOOK & LOOP SYSTEM (SEE FIG B , C , D)
FIT THE SANDING PAPER
Fit the sanding paper over the base. Make sure the sanding paper is even with the edges and that the
dust collection holes in the base and sanding paper is aligned and that the sanding paper is taut on the
base.
Lift the sanding paper retaining clips to the open position and insert one end of the sanding paper under
the retaining clip.
Push the clip back into the retaining position. Lightly stretch the paper over the base plate ensuring that
it is not folded or wrinkled then position under the other retaining clip back into the retaining position.
Check that the paper is flat to the base plate, if not, release either clip and reposition the paper before
resetting the clip. Switch on momentarily to check that the sander is functioning correctly. If there is
undue vibration, repeat the paper positioning procedure.
REMOVE THE SANDING PAPER
To remove the sanding paper, lift up the clamp lever and move away from the clamp lever lock. The
sanding paper clamp is now loose. Repeat with the other clamp on the opposite side of your sander.
2. USING THE DUST COLLECTION BOX (SEE FIG E)
A) ATTACH THE DUST BOX
Your sander is equipped with a Dust Collection Box (3), which is designed for collect dust task. Insert the
Dust Collection Box into the rear dust outlet of sander. Then pull the Dust Collection Box and make sure
it is tightened securely on the dust outlet.
B) EMPTY DUST BOX
For more efficient operation, empty dust box every 5-10mins. This will permit the air to flow through the
box better.
To empty the dust box, pull off the dust box out of the dust extraction outlet directly and shake out dust.
3. USING THE DUST OUTLET (SEE FIG F)
Set the desired cutting depth. Position the front part of the base plate flat onto the work surface. Make
sure that the blades are not touching the workpiece. Switch the machine on and push your planer
forward and it will start cutting. Always maintain all of the base plate flat on the work surface to prevent
the cutting blade jumping. Move the plane evenly over the work surface.
Be careful to avoid hitting nails during operation. It could nick, crack, or damage blades. We suggest that
you always keep an extra set of blades on hand for replacement.