EN-17
8. TORQUE ADJUSTMENT (SEE FIG. I)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is less when the torque adjustment ring is set on a
lower setting.
When drilling in masonry and concrete choose the hammer position
.
When drilling in wood, metal, plastic and screwdriver choose the drill position
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screws into soft and hard material
15 - 20 for driving screws into hard wood
21 for driving larger screws
for heavy drilling
for drilling in masonry and concrete
9. USING THE SIGHT LIGHT
To turn on the light, press the on/off switch and make sure the forward/reverse rotation control is on
right/left position. When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed area.
LED is also a battery capacity indicator. It will flash when power gets low.
10. BELT HOOK (SEE FIG. J)
Screw the Belt Hook on the tool with the screw provided in the plastic bag. The Belt Hook can be
hooked on your belt or pocket, etc.
11. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point to be drilled.
Depress the switch trigger to start the tool.
Move the drill bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force
or apply side pressure to elongate a hole.
If you want to activate the drill function (For drilling metal wood or plastic), turn the torque adjustment
ring on the drill position.
If you want to activate the impact function(For masonry or concrete), turn the torque adjustment ring on
the hammer position.
Tungsten carbide drill bits should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good condition. Always
use a magnetic bit holder (not included) when using short screwdriver bits.
When screw-driving, apply a small quantity of liquid soap or similar to the screw
threads to ease insertion.
12. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the machine immediately and release
the on/off switch. Then you can restart the tool soon.
