Saturnino mod. 2010
11
2016
7.
WATER FILLING
When the water in the boiler is over, the lamp “no water”
switches on (fig. 2 D). At this point disconnect the plug,
rotate the valve plug (fig. 3) of 360° and wait for steam to
go out completely. Unscrew the valve plug with care and
wait for 5/10 minutes.
Then fill the boiler up to desired level (fig. 6) paying
attention not to overfill the water on it (see section 4 point
1). Screw the safety valve plug again, connect the plug and
wait for the boiler lamp to switch off (fig. 2 C). Now the
iron is ready again.
While refilling the boiler, do not spill water onto the
machine. In the event this should happen, dry immediately
in order to avoid electrical risks.
8.
BOILER DISCHARGE
Empty the boiler periodically. Carry out this
operation when SATURNINO is turned off, cold (the
manometer has to mark 0 BAR) and the plug
disconnected. Wait at least 1 hour after the
switching off. During this procedure, wear proper
gloves in order to avoid accidental burns.
Unscrew the valve plug and turn the exhaust tap
(fig. 7), wait for all the water to come out and then
turn it off again. The tap might get clogged: in this
case, use a wire with a diameter of 3-4 mm or
similar and introduce it into the tube in order to
unclog it.
9.
GOOD FUNCTIONING
SATURNINO was designed and manufactured for the ironing of domestic garments.
It can be used maximum 20 hrs. per week (subdivided in many times) or 80 hrs. per
month.
10.
INTERVENTIONS AND SMALL REPAIRS
1.
It is advisable to empty the boiler every 2-3 times you use it.
2.
It is advisable to replace the gasket of the safety valve plug (use only original
gaskets) every 1200 hrs. of lighting or maximum 2 years, or earlier if it is
damaged. Carry out this operation when the machine is switched off and cold and
the manometer indicates 0 bar.
3.
If the electric wire is damaged, replace it immediately. The wire is supplied by the
manufacturer or authorized service centres.
Fig. 6
Fig. 7
