Saturnino mod. 2010
9
2016
3.
OPENING OF PACKAGE
1.
Open the box containing SATURNINO from the side marked with ALTO , take the
manual of instructions and read it carefully.
2.
Remove SATURNINO from the box and insert the cable support deep into the special
hole (fig. 1) placed on the back side of the generator.
3.
Fix the spring to the support hook, avoiding entwining (fig. 1).
4.
Place the iron on the rubber iron rest supplied with the machine (fig. 1).
4.
CONNECTION AND STARTING
With SATURNINO switched off and disconnected plug:
1.
Unscrew the safety valve plug of SATURNINO (fig. 3) and fill the boiler with water to
the desired level, paying attention not to overfill it.
It is recommend to use a funnel (fig. 6).
2.
Take the plug by the plastic part and screw it again: do not tighten too much or its
gasket might get spoilt (see section 7)
. N.B.: make sure the exhaust tap of the
boiler is closed (fig. 7).
3.
Insert the plug into a 230 V 16 A socket.
4.
Switch on the boiler (fig. 2 A), after 5 minutes switch on the iron (fig. 2 B) and
adjust the thermostat
on “cotton”
(fig. 4).
5.
Wait for the boiler lamp to switch off (fig. 2 C). Seize the iron by cork handle and
press the micro-switch of the iron (fig. 5) 4 or 5 times, so that steam comes out. It
is important to make sure it is a saturated steam (by pressing the micro-switch
with the iron pointed towards the floor). It is possible to adjust steam flux by
turning the hand-wheel placed on the solenoid valve (fig. 3). Now everything is
ready for ironing. During ironing operation, the boiler lamp switches on and off
signalling that the machine is working properly (fig. 2 C).
Fig. 2
Fig. 3
