Battipav Prime 9085/A, Operating Instructions Manual

Page: 47 / 156

47
Battipav srl GB
current and its length.
For cables up to 50 m long, a section of 4 mm2 is enough.
• Before connecting the machine to the power socket, check that the power supply voltage corresponds to that
shown on the plate on the machine.
• The machine must be connected to an effective earth wire.
In case of doubt, do not connect the machine.
IN THE EVENT OF REVERSE MOTOR ROTATION, INVERT THE TWO PHASE PINS INSIDE THE POWER
PLUG, AS INDICATED BELOW: only for codes art.9XXXX / T380 and art.9XXXX / T380S1
35 • with a screwdriver with a slotted impression, press in the appropriate seat and turn the
two phase pins;
• check the correct direction of rotation.
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment, disconnect the machine from the supply mains.
13
Loosen the 5 (five) nuts located on the blade cover guard and remove it.
Remove the blade fixing nut using the 30 mm spanner and the 5 mm Allen wrench.
THE BLADE FIXING NUT HAS A LEFT-HAND THREAD.
• Install the new blade, checking for correct direction of rotation as clearly indicated on the tool.
• Tighten the blade and put the blade cover guard back in position.
CONTROL DEVICES
14
The PRIME / SUPREME machine is equipped with a control board made up of:
36
For models INFINITY (art.xxxxx/S1)
1) START BUTTON: (GREEN COLOUR)
Press the button fully to activate machine starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop.
3) DEVICE FOR DISCONNECTION FROM THE MAINS (Plug):
Machine power supply point. During the maintenance phases, take out the plug from the device in order to
disconnect the machine from the mains.
4) MAINS PRESENCE WARNING LIGHT (WHITE):
On: presence of mains voltage. Off: lack of mains voltage.
5) MACHINE OPERATION WARNING LIGHT (GREEN):
It indicates that the machine is working.
6) OVERCURRENT CIRCUIT BREAKER:
It intervenes when there is overcurrent, interrupting the machine supply. Its intervention is indicated by the
expulsion of the manual reset. In case of intervention of the circuit breaker, wait a few minutes and reset it by
pressing its central pin.
7) LASER MARKER (Optional on 9055, 9085, 9100, 9120, 9150 e 9200)
It projects the cutting line on the table. It is enabled when the machine is connected to the mains.
CUTTING ON THE TABLE
15
BEFORE STARTING THE CUTTING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT
AT LEAST 150 cm ARE LEFT FREE AROUND THE MACHINE. IN ORDER TO WORK IN SAFETY
CONDITIONS, DO NOT LET OTHER PEOPLE REMAIN NEAR THE MACHINE DURING THE CUTTING
OPERATIONS. BEFORE PERFORMING THE CUTTING OPERATIONS, MAKE SURE THAT THE
MATERIAL IS PROPERLY LEANED AGAINST THE TILE STOPPER.
CUTTING FOR THICKNESS OF UP TO 110 mm
16
With the locking lever, lower the motor head until placing the cutting blade some millimetres below the working