30
Battipav srl
GB
Battipav srl
6
MOVE THE MACHINE.
POSITIONING
Place the machine on a stable surface.
To place the machine in working position, proceed as
follows:
CAUTION
MAKE SURE THAT THE MOTOR HEAD IS LOCKED
IN THE LOWERED POSITION BY MEANS Of THE
LOCKING LEVER LOCATED ON THE MOTOR SIDE.
MAKE SURE THAT THE SLIDING CARRIAGE IS
LOCKED BY MEANS Of THE CARRIAGE LOCKING
STOPPER.
7A
a) put the leg locking pins in release position;
7
b) by means of the transport handles, lift the rear
side (motor side) until the working position.
CAUTION
8
fOR CORRECT MACHINE POSITIONING, MAKE
SURE THAT THE LEG UPPER HOLE MATCHES
THE LEG COUPLING HOLE, BEfORE fINALLY
LOCKING IT.
8
c) lock the legs one at a time;
CAUTION
HOLD THE MACHINE DURING THE LOCKING
PHASES.
d) Repeat the operation for the opposite side;
CAUTION
7
If THE LEGS ARE COMPLETELY REMOVED, PUT
THEM BACK WITH THE 4 HOLES DOWNWARDS
AND OUTWARDS.
e) Release the working table by means of the
locking pin;
9
f) Move the working table backwards;
g) Turn the rear splash guard.
10
h) Remove the blade cover tie rod locking screw;
11
i) Turn the blade cover until moving the water
on-off tap;
l) Lever the blade cover so that the blade cover
tie rode can pass easily.
12
m) Put the blade cover tie rod in position;
13
n) Lock the blade cover tie rod with the screw
provided that had been previously removed;
o) In case of difficulty in engaging the screw,
move the blade cover slightly.
14
p) Engage the water hose on the water on-off
valve and place the rear splash guard back in
position;
15
q) With a 6 mm Allen wrench, secure the working
table handle;
CHECKING BEfORE USE
CAUTION
THE EXPERT MACHINE HAS BEEN DESIGNED fOR
WORKING EXCLUSIVELY WITH WATER.
16
• Before any cutting operation, make sure that
the water level inside the tank is the same as
the one.
17
• Make sure that the power supply cable does
not interfere with the cutting operations.
Use the cable locking stopper to direct its
passage.
CAUTION
Before using the machine, check there is power
supply.
BLADE ASSEMBLY / DISASSEMBLY
18
Loosen the 5 (five) nuts located on the blade
cover guard and remove it.
Remove the blade fixing nut using the 30 mm
spanner and the 5 mm Allen wrench.
