Instruction Manual
for WPT, KTS, KPS, KTM, WSM series use and maintenance
pag. 63
ENGLISH
Figure 14
10.3.2 - BLADES REPLACEMENT
1. Check that there is sufficient space at the back of the Rotary blades vacuum pump to be able to work easily; if there is not,
the Rotary blades vacuum pump should be taken off its support beforehand;
2. Remove the back;
3. Extract the blades from the rotor;
4. Clean the Rotary blades vacuum pump;
5. Replace the blades and the gaskets and the oil seals of the rear flange;
6. Re-fit the back of the Rotary blades vacuum pump.
7. Use only Battioni Pagani
®
e original spare parts
Request the Rotary blades pump revision kit containing in a single blister pack: Original Battioni Pagani
®
blades, gaskets and oil seals.
10.3.3 - BLADES DIMENSION
MODEL
NUMBER OF
BLADES
BLADES SIZE
WPT 480
6
300x73x7,5
WPT 600
6
400x73x7,5
WPT 720
6
500x73x7,5
KTS 840
6
500x80x6,7
KTS 960
6
570x80x6,7
KTS 1080
6
640x80x6,7
KPS 490
5
460x60x6,5
MODEL
NUMBER OF
BLADES
BLADES SIZE
KPS 550
5
410x82,5x7,5
KPS 670
5
500x82,5x7,5
KTM 1200
6
529x98x7,5
KTM 1500
6
639x98x7,5
KTM 1800
6
555x125x7,5
KTM 2300
6
650x125x7,5
WSM 2700
6
678x128x7,5
WSM 3300
6
828x128x7,5
Table 9
IMPORTANT: Make sure that the blades received for replacement are of less or equal length to the
nominal size shown in Table 9.
10.4 - RUBBER BALL REPLACEMENT
1. Unscrew and lift the valve holder lid (WPT and KTS series)
2. Replace the rubber ball;
3. Close the valve holder lid (WPT and KTS series)
