Rev. A-021210
Page 1
P/N VDC E12248-S2-MNL
BatteryMINDer
®
E12248-AA-S2
Simplified Operating Instructions
(Read and thoroughly understand ALL SAFETY Instructions
on pages (3-7) and Qualifying Your Battery pages 8-11,
BEFORE proceeding further.
1. Attach a battery connector assembly (supplied) to output
cordset of charger, either the clips or ring terminal assembly, -
NEVER BOTH at same time.
2. Attach output to battery terminals-
RED
band =Po
BLACK
band = Negative.
2-a: Attach temperature sensor ABS-248 to battery and then to
charger*.
. Plug AC power cord into 220/240 Vac electrical outlet.
Observe REVERSED Polarity LED indicator. If lit
RED
, reverse
battery connector attachments on battery.
4. Observe
GREEN
LED indicator labeled Charge-Float = Solid
when charging, Blinking when maintaining battery(s).
Charger will
automatically start within 0 seconds or less.
5. Observe Battery Connected - Error Indicator, LED Must be lit
GREEN.
**
IF IN DOUBT REGARDING ANY OF THE ABOVE, REFER TO
FULL INSTRUCTIONS
* See detailed instructions for need and method of properly con-
necting sensor to battery, pgs. 21 - 2.
** See full instructions if not lit
GREEN
.
