11
4) DO
NOT
plug the ring terminal harness into the jump pack until it is
connected to the battery first.
5) Secure the control box with the Battery Tender® logo using the mounting
slots.
6) Route the wiring so that you have easy access to the connector.
7) When a jump start is required simply plug the connector directly into the
receptacle on the end Jump Pack (Car with hood open symbol).
1) Use the supplied micro USB cable to charge the Vehicle Jump Starter &
Portable Power Bank.
NOTE:
While charging all the other features and functions are NOT active.
2) There are four (4) blue LED’s that show the state of charge of the internal
lithium battery. Simply press the touch button to activate these LED’s.
3) Each LED shows a percentage of charge of the internal lithium battery.
a. 0% - 24% remaining LED 1 flashing.
b. 25% - 49% LED 1 solid, LED 2 flashing.
c. 50% - 74% LED 1 & 2 solid, LED 3 flashing.
d. 75% - 99% LED 1, 2 & 3 solid, LED 4 flashing.
e. 100% Charged, all of the LED’s are solid and will go into sleep mode
after 10 seconds.
4) The battery level should be checked and charged every three (3) months.
5) DO NOT use any other charger to charge this Vehicle Jump Starter &
Portable Power Bank.
6) Doing so can damage the internal battery and be very dangerous.
7) When charging the internal battery, work in a well-ventilated area and do
not restrict ventilation in any way.
CHARGING THE VEHICLE JUMP STARTER AND PORTABLE
POWER PACK
12
1) The device shall be stored indoors and protected from the elements.
2) The unit shall not be charged outdoors.
3) When in use, steps should be taken to reduce the exposure to rain, sleet,
snow, and the like.
1) There are three (3) USB ports contained in your Jump Starter & Portable
Power Bank. Once your device is connected you must press the touch
button to activate charging.
a. Standard USB Output port - 5VDC/2.4Amp. Used to charge your cell
phone, tablet etc.
b. Type – C USB Input port – 5VDC/2Amp. This port is for charging your
Jump Starter & Portable Power Bank. Only use the supplied cable to
charge your Jump Starter & Portable Power Bank.
c. Micro USB Input port – 5VDC/2Amp. This port is for charging your Jump
Starter & Portable Power Bank. Only use the supplied cable to charge
your Jump Starter & Portable Power Bank.
1) To turn the LED lights ON simply hold the Touch Button down for at least
two (2) seconds.
2) To turn the LED lights OFF hold the Touch Button down for at least two (2)
seconds.
CAUTION
USB PORTS
LED FLASHLIGHT