9
1) Before jump starting your particular vehicle always check the manufacturer
instructions/recommendations/warnings first.
2) Check the battery level of the Vehicle Jump Pack by pressing the touch button
before jump starting your vehicle.
There must be a minimum of TWO (2)
LED’s illuminated.
3) Insert the smart alligator clip connector or the ring terminal harness connector into
the receptacle on the end Jump Pack (Car with hood open symbol).
4) Connect the RED positive clip to the positive post on the battery, then the
BLACK negative clip to the negative post on the battery.
5)
CAUTION:
Ensure the Vehicle Jump Pack and smart alligator clip cables are
clear of all vehicle fan blades/belts/pulleys etc. before proceeding.
6) The LED on the smart alligator clips will then turn GREEN. Wait 5 to 10
seconds then start your vehicle.
7) Remove the clips
IMMEDIATELY
after the vehicle has started. Black negative
clamp first.
8) DO NOT use the Vehicle Jump Starter to repeatedly try and start your vehicle.
Wait at least thirty (30) seconds between attempts. Check vehicle after three
attempts.
JUMP STARTING A VEHICLE
10
The smart alligator clips contain a single Amber/Green LED along with a warning
buzzer for Faults and Error protection:
1) If correctly connected the LED on the smart alligator clips should turn
green.
1) Standby Mode – Clips are not connected – The Green LED Flashes.
2) Vehicle battery voltage to LOW - Amber LED On, buzzer is beeping
3) Vehicle battery voltage to HIGH - Amber LED On, buzzer On solid.
4) Alligator clips connected to vehicle battery in reverse polarity. (Red clip to
Black negative terminal, Black clip to Red positive terminal). Amber LED
On, buzzer is beeping.
5) Short circuit protection - Amber LED On, buzzer is beeping.
6) Overheat protection – Amber LED is Flashing, buzzer is beeping.
Use this harness to connect directly to your battery.
1) Connect the RED ring terminal to the POSITIVE battery terminal.
2) Connect the BLACK ring terminal to the NEGATIVE battery terminal.
3) WARNING: If you connect the ring terminals to the battery in reverse
polarity then plug the harness into the jump pack it may cause damage
to the jump pack.
RING TERMINAL WIRE HARNESS
SMART ALLIGATOR CLIPS