P1512120 R3
33
Figure 9.
Wheel Over-Center Handle Positions
Engaged
Disengaged
2. Set and run the gas engine at approximately half throttle.
3. Refer to the controls shown in
Figure 10 on page 33
.
4. Before moving the conveyor into position:
•
Fully lower the conveyor.
•
Raise the intake end slightly off the ground to position the conveyor.
•
Raise the conveyor discharge end only for final positioning such as when next to a storage bin or grain
truck.
Figure 10.
Mover Kit Controls
If Operating the Mover Kit in Temperatures Below -10°C (14°F):
• Disengage the pump when starting the motor cold. This will put less pressure on the starter and allow the
motor to turn over easier, helping it to start.
• Allow the hydraulic oil to warm before using the self-propelled kit.
PORTABLE GRAIN BELT CONVEYOR – S-DRIVE FIELD LOADER
4. PLACEMENT
