Batca LINK DUAL FUNCTION LD-9, Owner'S Manual

Page: 9 / 20

www.batcafitness.com
9
LD-9 Owner’s Manual
Figure 2
Step 2:
Item # Part # Description Qty
4 BFP-10914 Chin/Dip Pole 1
5 BFP-10849
Guide Rod Plate
1
6 BFP-51745 Guide Rod 2
7 BFM-10413 Top Weight Plate 1
8 BFM-50632 Weight Stack Plate 19
9 BFH-50529 Rubber Donut 2
10 BFP-51740 Rear Weight Stack Shroud 1
26 BFM-51173 Weight Stack Pull Pin 1
Make sure all bolts are
tightened
EXCEPT FOR
THE FOUR BOLTS ON THE
SHROUD
before moving on. Do
not tighten the bolts for the
shroud until step 6.
All Flat Washers and Nylocks are 3/8” unless
otherwise noted. Anywhere a washer is against the
round side of a tube there is to be a
3/8” CURVED
WASHER instead of a 3/8” FLAT WASHER. Item # Part # Description Qty
28 BFH-50174 4 1/2” Pulley 1
29 BFP-52340 BHSCS 3/8” x 3/4” 2
30 BFH-50254 HCS 3/8” x 3/4” 2
35 BFP-51752 SHCS 3/8” x 2 1/4” 1
39 BFP-51760 SHCS 3/8” x 3 1/2” 2
42 BFP-52379 BHSCS 3/8” x 4 1/2” 1
43 BFP-51799 SHCS 3/8” x 5” 2
46 BFH-50204 3/8” Curved Washer 2
47 BFH-50146 3/8” Flat Washer 12
48 BFH-50157 3/8” x Nylock 6
To counter balance the seat, pin
the weight stack on the third
plate from the top as shown in
the figure to the right. Use a
BHSCS 3/8” x 4 1/2” bolt. Refer
to figure on page 16.