www.batcafitness.com
7
AXIS Free Trainer Owner's Manual
Step 1:
Note: Please Position Hardware in the same direction as shown in the figure. This will
make future steps easier to assemble
PLEASE READ AND FOLLOW ALL DIRECTIONS VERY CAREFULLY FOR PROPER INSTALLATION.
All Flat Washers and Nylocks are 3/8” unless otherwise noted.
Anywhere a washer is against the
round side of a tube there is to be a
3/8” CURVED WASHER
instead of a
3/8” FLAT WASHER.
*The
ANY* Axis
parts Note above is referring to the fact that any combination of the
Axis Free Trainer, the Axis Bodyweight Trainer, The Axis Smith Machine, or the Axis
Freeweight Rack can be assembled together in any configuration. Regardless of which of
these combinations are installed together the instructions for installation are the same.
Please keep the parts from the Main Units separate from each other to avoid confusion
during assembly.
DO NOT TIGHTEN BOLTS
Part #
Description
Qty
Refer to Manual of
Corresponding AXIS Unit
ANY* Lower Axis Frame (Right Side)
2
Refer to Manual of
Corresponding AXIS Unit
ANY* Lower Axis Frame (Left Side)
2
BFM-11097
Axis Lower Cross-Member
2
BFM-11134
Axis Main Unit Connector 1
1
BFM-11135
Axis Main Unit Connector 2
1
BFM-11133
Axis Main Unit Connector 3
1
BFM-52813
AXIS Screw Cap
8
BFP-51747
SHCS 3/8” x 3”
4
BFP-51748
SHCS 3/8” x 3 1/4”
4
BFP-52345
SHCS 3/8” x 4”
2
BFH-50204
3/8” Curved Washer
2
BFH-50146
3/8” Flat Washer
8
*If you are connecting 3 Main
AXIS Units these four bolts
will need to be SHCS 3/8” x 3 1/4”
instead. They are packaged with the
AXIS Shelf Connector B.
The chrome AXIS
Screw Caps are
packaged in the Hardware
Blister Packs for the Main
AXIS Units.
*AXIS Main Connector 3 is only
purchased if you are connecting
3 AXIS Main Units. If you are
connecting only 2 AXIS Main Units,
you do not need this part. This part
and it’s hardware are packaged with
the
AXIS Shelf Connector B.
