English
8
Multimaterial brush:
regular maintenance
and cleaning of various materials: stone,
wood, tiles, etc.
The following two brushes are also available
separately:
Steel brush:
removing very stubborn dirt,
moss and scale.
Spiral brush (green): Option 1 –
suitable as
an artificial grass brush to make your artifi-
cial grass look tidy. With this brush the
fibres are brushed upright again, making
your artificial grass look like new again.
Option 2 –
removing stubborn dirt.
5. Before first use
• Remove the device and all additional
parts out of the packaging.
• Check all parts for damage in transit
and do not use a damaged device.
• Keep packaging materials out of reach
of children. There is risk of suffocation!
6. Operation
• Make sure the power mains voltage
corresponds to the operating voltage
stated on the type label.
• Use only suitable extension cords for
outdoor use. Preferably use extension
cords with a cable H07 RN-F; 3 x 1.5
mm
2
. If in doubt, refer to a professional.
• We recommend using a residual current
circuit breaker with a nominal residual
current of ≤ 30 mA.
6.1
Secure the extension cord one the
strain relief hook
(7)
by forming a loop
(See
Fig. B
).
6.2
To switch on the device press the safety
button
(4)
first and then press the ON/
OFF trigger
(6)
. Release the safety but-
ton (See
Fig. C
).
6.3
With the speed adjusting wheel
(3)
you
can steplessly set the speed of the
brush roller.
Use the multimaterial brush for regular
maintenance and removal of dirt:
– Place the multimaterial brush in the
machine, see chapter: changing the
brush.
– Set the speed control
(3)
to position 3.
– Place the machine on the material to be
cleaned. Switch on the machine by
pressing the safety switch and then the
ON / OFF switch.
– Increase the speed to the desired posi-
tion depending on the material.
Use the steel brush or spiral brush for
removing stubborn dirt:
– Place the steel brush or spiral brush in
the machine, see chapter: changing the
brush.
Note the steel brush is sharp!
Always wear gloves when installing
or removing the steel brush.
– Set the speed control
(3)
to position 3.
– Place the machine on the material to be
cleaned. Switch on the machine by
pressing the safety switch and then the
ON / OFF switch.
– Increase the speed to the desired posi-
tion depending on the material.
Do not use the steel brush on soft
stones or tiles with imprint, the
steel brush may damage them.
Always test a small, inconspicuous
piece first to check that the steel
brush does not damage the mate-
rial to be cleaned. The steel brush is
suitable for removing stubborn dirt.
On wood the steel brush can also
act as a sanding machine, remov-
ing the top layer of the wood.
Do not use the steel brush for regu-
lar maintenance, use the multi
material brush for this.
Use spiral brush for artificial grass:
Before brushing, it is important to clear the
artificial grass as much as possible from
leaves, twigs, waste, etc. This can be done
with the help of a leaf blower and / or rake.
Never brush the artificial grass when the
artificial grass is wet.
– Make sure the spiral brush is clean.
– Insert the spiral brush into the machine,
see chapter: changing the brush.
– Set the speed switch
(3)
to position 3.
– Place the machine on the artificial grass
and switch on the machine by pressing
the safety switch and then the ON / OFF
switch.
