9
English
13. Cleaning and maintenance
13.1
Cleaning
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap. Do not use any cleaning or sol-
vent materials; these can attack the
device’s plastic components. Make sure
that no water can get inside the electric
power tool.
• Remove the battery before undertaking
any cleaning or maintenance work.
• Clean the magazine. Remove dust and
wooden chips which may have accumu-
lated in the magazine.
• Use only a moist cloth to clean the unit.
Do not use aggressive chemicals which
may dissolve plastic parts, or abrasives.
Always keep the ventilation slots clean
and free from obstructions.
• Regularly inspect all mounting screws
and ensure that they are properly tight-
ened. Should any of the screws be
loose, re-tighten them immediately.
Failure to do so could result in serious
hazard.
• The motor unit winding is the very
“heart” of the power tool. Exercise due
care to ensure the winding does not
become damaged and/or wet with oil or
water.
13.2
Maintenance
There are no inner parts of the tool which
need maintenance.
14. Technical data
Battery voltage: . . . . . . . . . . 18 V Li-Ion
Firing speed: . . 60 nails/staples per minute
Max. magazine capacity:. 100 nails/staples
Max. length of nails:. . . . . . . . 20-50 mm
Max. length of staple: . . . . . . . 19-40 mm
Weight: . . . . . . . . . . . . . . . . . . 2.8 kg
Weighted sound pressure level L
pA
: 79.9 dB(A)
Uncertainty K
pA
: . . . . . . . . . . . . 3 dB(A)
Weighted sound power level L
WA
: 90.9 dB(A)
Uncertainty K
WA
: . . . . . . . . . . . . 3 dB(A)
Hand/arm vibration:. . . . . . . . . 1.39 m/s
2
Uncertainty K: . . . . . . . . . . . . .1.5 m/s
2
14.1
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given
in EN 60745; it may be used to compare one
tool with another and as a preliminary
assessment of exposure to vibration when
using the tool for the applications
mentioned
• using the tool for different applications,
or with different or poorly maintained
accessories, may significantly increase
the exposure level
• the times when the tool is switched off
or when it is running but not actually
doing the job, may significantly reduce
the exposure level
Protect yourself against the effects of vibra-
tion by maintaining the tool and its accesso-
ries, keeping your hands warm, and organiz-
ing your work patterns.
