ASSEMBLY
Before you begin to place the enclosure on, you might want to
clean
your PCB. You can use e.g.
isopropyl alcohol. Put some of the liquid all over the PCB using the brush, let it act for a while and
sweep it off. Then just let it dry. You can repeat these steps until you are satisfied with the result.
After this step you can finally add the
switch
and mount the 6 mm mushroom head
screw
with the 18
mm
spacer
on the regulator.
14
Summary of Contents for 60 KNOBS
Page 8: ...Let s solder the resonator and the fuse as well These parts are not oriented 8...
Page 9: ...9...
Page 13: ...13...
