Instruction
Manual
for
HST-Synchro
20, 40, 60 and 80
page 8
Storage
If you store HST-Synchro or if it is not in use, please see that it is dry and use oil to protect it
against corrosion.
Maintenance
HST-Synchro has to be cleaned in regular intervals depending on the degree of pollution. Do
not use aggressive solvents or loose fibers as e.g. cotton waste.
Checklist for Optimal Tapping
1.
Check if the tap is new and has the right geometry for the intended application. It has to
be aligned correctly with the bore hole.
2.
Check if the rpm of the machine spindles has been programmed correctly.
3.
Are feed and feed stop correct, so that the tap will not hit the ground of the bore hole and
break?
4.
Check if the workpiece is clamped firmly and that it will not become loose during
machining.
5.
Did you pre-drill a bore hole with the correct diameter?
6.
Check the programming of start and end position of the tool. At the end of the cycle the
tool must have left the bore hole completely.
7.
Did you choose the right coolant / lubricant for the threading tool?
8.
If you want to tap a blind hole, check if there is enough space for the chips.
Repair
Address for our repair service:
BASS GmbH & Co. KG
Technik für Gewinde
Bass-Strasse 1
97996 Niederstetten
Deutschland • Germany
Tel.: +49 7932 892-0
Fax: +49 7932 892-88
E-Mail: [email protected]
or contact your BASS representative.
Dispatch of tap holders in need of repair:
Please send the complete HST-Synchro with collet and wrench to above mentioned address.
The following declaration should be stated on your repair order:
„We agree to repair and return of enclosed HST-Synchro, as long as the total costs do not
exceed 40% of the value of a new HST-Synchro.“
We are going to repair your HST-Synchro and return it together with the invoice by UPS
(parcel post on request). If the total repair costs exceed 40% of a new HST-Synchro, we are
disposed to send you an estimate of costs in advance. Repair will only be executed after
receipt of your approval.
Version 5/09 e
