User manual - COUNTER
7.3.10.
”SECu” menu
This menu contains presets connected with availability of other parameters:
“SEtCod”
- user password (4-digits number). If this parameter is set at value
“0000”
, user
password is turned off.
If the user do not remember his password, the access to the menu is possible
by the “one-use password”. To get this password please contact with
Marketing Division. “Single use password” can be used only one time, after
that it is destroyed. Entering this password causes in clearing of user
password, it means sets the user password to „0000”.
The “one-use password” can be used
ONE TIME ONLY
, it is impossible to use it
again! The “one-use password” can be restored by Service Division only.
“A rEL1”÷“A rEL4”
- this options permits user (
”on”
) or prohibits (
”oFF”
) to modify the
thresholds of the relays/LEDs R1 ÷ R2 without knowledge about user
password.
The diagram of quick view mode is presented in figure 7.1.
“A oFFS”
- this option permits user (
”on”
) or prohibits (
”oFF”
) to modify the
”oFFSEt”
parameter value without knowledge about user password. The possibility of
offset changing without knowing of password, allows to use of the counter as a
batcher
From counting (batching) mode to quick check of the thresholds user can goes by
pressing
[^]
button. Depending on the
„A oFFS”
value it is possible to use two different
operation modes of „quick view” (see: Figure 7.1, Figure 7.2).
31
i
Summary of Contents for BDC94
Page 46: ...User manual COUNTER BDC94 46 ...
Page 47: ...User manual COUNTER BDC94 47 ...
