6. Screw motor bracket to board. Screw motor to motor bracket with 2 screws.
7. Screw actuator to motor using 4 remaining screws.
8. Thread fishing line out the top, and press the spool onto the motor shaft (glue if needed).
9. Tie a loop, and girth hitch the fishing line to the snap shackle.
10. Solder motor wires.
11. Screw motor bracket to board.
Printed Circuit Board
It is possible to wire by hand, but it is much easier and more reliable to use a printed circuit
board (PCB). You can have small runs made by services like
13
