9
866 294 5847 | baselinesystems.com | [email protected]
BASELINE CLOUD NETWORK MODULE
1. Thread the coax connector on the antenna
cable onto the stem of the antenna and
hand-tighten it. Route the antenna cable
towards the bottom of the antenna riser.
2. Insert the tabs on the backing plate into
the holes at the top edge of the riser and
make sure the plate is snug along the back
of the riser
3
Installing the Cloud Network Module into a Pedestal Cabinet, Cont.
1. Open and remove the front door on the
lower part of the pedestal.
2. On the inside left wall of the pedestal,
remove the nuts from the bolts that
secure the cover to the outside wall. Set
the nuts aside to be replaced in a later
step.
3. Remove the bolts that are holding the
cover on the outside wall. Set the bolts
aside to be replaced in a later step.
4. Remove the cover from the outside wall,
making sure that the gasket stays in place.
4
5
1. On the inside left wall of the pedestal,
note the hole that is covered by the
gasket.
2. On the outside left wall of the
pedestal, find the location of the hole
and use a sharp hobby knife to remove
the gasket material that is covering the
hole.
Note:
This opening is used to route the
antenna cable inside the pedestal in
order to connect it to the Cloud Network
Module. Make the hole large enough to
pass the cable through, but small enough
to maintain the seal.
