- 11 -
Mount the hand wash basin
Hang the hand wash basin near the water supply.
Before mounting the hand wash basin, check the parameters of the wall where
the basin is to be installed. The wall should be able to support the weight of the
hand wash basin.
Mark 3 points in the appropriate place on the wall via the holes in the installation
rack (fig. below).
Drill the holes in the wall and place the supplied brackets in.
Attach the support rack to the will with the screws.
Then, hang the basin on the upper edge on the support rack.
Cold / hot water supply
Using the flexible hoses connect the cold water connection (11) and hot water
connection (13) with the mixer fitting (12). Using the screw (8) you can adjust the
hot/cold water ratio (fig. 3).
Drain connection
Connect the hand wash basin with the drain pipe.
To do so, use the supplied connection pipes and siphon.
A.
Measure off the required length of the connection
pipe from the basin drain to the connection in the
wall and cut to the size as needed. Then, fasten
the connection pipe with the siphon.
Place the connection pipe in the socket of the drain
pipe in the wall, put the gasket and tighten.
B.
Place the other end of the siphon in the drain socket
of the hand wash basin. Here place the gasket as
well and tighten the whole set using the siphon pliers
and nuts.
B
A
