- 9 -
2. Install the supplied swivel fitting (1) on
the right back edge of the hand wash
basin (4) (rys. 2).
3. To do so, unscrew the plastic nuts (2)
from the underside of the swivel fitting (1)
and remove the washers.
4. Insert the thread of the swivel fitting (1)
through the hole in the hand wash
basin (4). Place one washer supplied
with the unit between the basin and
swivel fitting (1) and another washer
between the basin (4) and the plastic
nut (2).
5. Replace the plastic nut (2) on the thread
of the swivel fitting (1) on the underside
of the hand wash basin (4) (fig. 2).
Fig. 2
6. Tighten one end of the flexible hose (3) to the swivel fitting (1) connector.
7. Install the drain set to the drain of the hand wash basin. Make sure that the thin
gasket in the hand wash basin between the drain set and basin, and the thicker
gasket between the bottom and nut are fiitted under the hand wash basin (fig. 2).
4
1
3
2