Installation and operation
14 / 22
120325
EN
5.2
Operation
WARNING
Injury hazard!
Blades of the cutting disks are very sharp!
Always wear sturdy, soft and cut-resistant five-finger gloves when
attaching, removing, cleaning the cutting disks to allow a firm grip on the
items.
Never press the cut products with hand, always use delivered pusher!
Appliance Preparation
1. Before use, thoroughly clean the appliance and equipment observing
instructions in section
6.2 'Cleaning'
.
2. Prepare products for cutting.
3. Select appropriate cutting disks and install them in the appliance before starting
the cutting process.
Fig. 3
Fig. 4
4. Use the knob to loosen the safety
lock by rotating it counter-clockwise.
5. Raise the stamper lever high and
open the protective cover wide.
6. First, fit the plastic ejector disk and
then the cutting disk of your choice.
ATTENTION!
The fitting of the ejector disk is essential for proper operation of the
machine. The ejector disk should always be fitted first.
7. Close the protective cover and secure it by rotating the safety lock knob
clockwise.
Summary of Contents for GMS550
Page 1: ...GMS550 120325...
