- 38 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
If during transport the device was placed horizontally, the connection may
occur only after a period of 2 hours (built-in condensing unit).
After a power failure or if the plug is removed, the device should not be
connected to the power supply for at least 5 minutes.
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
5.2 Operation
Preparation and start-up
Before first use, clean the refrigerated counter . Please refer to the guidelines in
Se on 6 "C ean ng and Ma n enan e“
.
Connect the device to a single, earthed socket.
Switch on the device using the
ON/OFF
network switch on the front of the device.
The Green LED power indicator in the switch comes on. The current temperature
inside the device is shown on the digital display.
Before using and placing any foodstuffs, the device should first obtain the desired
temperature.
Digital temperature control
Basic settings of the temperature are pre-set and reflect the operating temperature in
the range of 0 °C
– 10 °C inside of the device. During normal operation of the device the
digital display indicates the current temperature inside of the device.
Button
Functions
Display a required value, select parameters
in programming mode or save the procedure
Manual start of defrost
In programming mode, select a parameter
code, increase the displayed value
AUX
In programming mode, select a parameter
code, decrease the displayed value
