- 26 -
5.2 Installation and connection
CAUTION!
Installation and connection of the device should be performed only by a qualified
specialist.
Setup
•
Unpack the device and remove all packing material. Remove the protective film from
the device.
•
Locate the device in a safe place where the weight of the device and food products
contained inside are sufficiently supported.
•
Never put the device on a flammable surface.
•
To avoid damage to the compressor, when setting up or transporting the device do
not tilt it to a degree in excess of 45º.
•
Do not place the device near sources of open flame, electric ovens, electric heaters
or other heat sources such as direct sunlight. High temperatures may damage the
device's surface and have a negative impact on cooling efficiency and energy use.
•
Locate the device so that sufficient air circulation is ensured. Keep a distance of at
least 10 cm at the sides and rear from walls and other objects. Leave sufficient
space at the front for personnel.
•
Never cover the device's ventilation ducts.
•
Never place the device in locations with high ambient humidity. Too much moisture
may damage the device.
•
Do not drill any holes or mount any objects on or in the device.
•
Do not place any heavy objects on the device.
Connecting the device
•
If the device has not been transported in a horizontal position, wait at least 2 hours
for the coolant to settle before connecting it to a power source.
•
In the event of a power outage or if the device is unplugged, do not reconnect
the device to the power network for at least 5 minutes.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
