11
ENGLISH
GB
When the device is to be installed
near the walls, partitions, kitchen
cabinets, decorative elements, etc.,
they must be made from non-
flammable materials or covered with
suitable non-flammable materials.
To ensure the correct operation
of the appliance, the appliance must be
installed and operated in the
thoroughly ventilated room only.
8.3.
Installation of the appliance in a line
To fix the appliance in a line (neighboring) follow
the steps:
1.
Dismantle the control panel, and remove the
cast iron frame from the chimney if necessary.
2.
Apply the sealing tape (
A
) onto the joining
sides.
3.
Place the appliances next to each other and in
a horizontal position (by adjusting the feet).
4.
Connect the appliances with the joining
elements.
8.4.
Connection to the mains (service technician)
The device may be connected to the power supply
only by the authorized and qualified personnel,
when the valid regulations are followed and when
appropriate material is used in accordance to the
regulations.
Depending on the model the devices are designed
for connection to the following networks:
380-415 V 3N~ 50-60 Hz
During the installation follow the data on the rating
plate.
For direct connection to the
network install the device assuring
disconnection from the network, having
spacing of contact large enough for
disconnection in conditions of over-
voltage category III, which conforms to
the installation principles.
To correctly connect the device, follow the
guidelines below.
E
D
UC
A
Summary of Contents for 296215
Page 115: ...ANLAGEN ATTACHMENTS ANNEXES ALLEGATI ANEXOS ANEXOS BIJLAGEN ZA CZNIKI...
Page 116: ......
Page 124: ...NOTE...
Page 125: ...NOTE...
