Bartscher 1K1050, Instruction Manual

Page: 15 / 23

- 36 -
5.1.3 Gas connection

Use the device with the gas tap according to EN16129 standard and with the gas
hose marked CE and at least 1 metre long.
They are not included in the delivery. We recommend the Bartscher gas
connecting set, code-no. 500180.

Follow the gas supplier instructions about the gas cylinder operation.

Never use the gas cylinder with damaged surface, valve, flange or foot rim. Dented
or rusted gas cylinder may be dangerous and should be checked by the gas
supplier.

Never connect the device with a non-regulated gas source.

When the device is not in use, close the gas cylinder valve.

The device is allowed to be used with propane, butane only.

Use only the gas cylinders of a weight up to 15 kg .

Connect one end of the gas hose to the pressure regulator and the other end to the
gas burner. Make sure that the connection is strong and there is no damage on the
components and fiitting.

Pay attention that the gas hose is not twisted or kinked, and it is not in contact with
any hot elements of the gas stool cooker.

Check the gas hose once a month and always when changing the gas cylinder.
The gas hose used with the device need to be replaced every 5 years. When the
gas hose has cracks, fissures or other damage it needs to be replaced with a new
one immediately.

Before connecting the gas cylinder, make sure that the valve is closed and there is
no open fire (oven, etc.) in the vicinity of the device. Make sure that the seal is in a
good condition. Next, connect the pressure regulator with the gas cylinder.

The gas cylinder needs to be always placed in the standing position for proper
operation of the gas connection when using the device.

To replace the gas cylinder, make sure that the valve is closed and there is no open
fire or heat source in the vicinity of the device.

Be careful when handling connections or other elements.

Do not place the gas cylinder up side down to fully use its content.

After installation of the device, perform the tightness test of all the gas hoses using
soapy water or leak detector spray.