Page 14 of 21
Ver.1.1
9
Troubleshooting
The induction unit may only be opened by approved, specially trained service
Employee.
If the heating zone (ceramic glass surface) is cracked or broken, stop working with
the equipment at once. Turn off the induction unit immediately and pull the main
plug from the socket. Do not touch any parts inside the unit.
Error
Possible cause
Error: correction by User-
or Service staff
Pan does not heat; operation indictor
lamp is OFF (dark)
No current supplied
Control, is the unit connected to the
power (Power cable connected?), Main
switch is in Off Position, check Fuses.
partly also in On-Table units like Model
BI4KTH14
Power control knob
in OFF position
Main switch is in Off Position
Turn Power control knob in ON position.
Pan too small (pan
bottom diameter
smaller than 12 cm)
Use the right Pan.
Pan not placed in the
centre of the heating
zone (pan cannot be
detected)
Put the Pan in the middle of the Heating
Zone.
Unsuitable pan
Choose for the Induction suitable Pan
*1.
Induction
unit
defective
Contact your Dealer for the Repair
service. Disconnect the Unit from the
Power.
Insufficient heating
power;
operation indicator lamp is ON
Pan used not ideal
Choose for the Induction suitable Pan.
Compare the result with your Pan.
Air
cooling
system
blocked
Take sure, the Air circulation is working
(Not Blocked).
Air filter clogged
Clean Filter or replace Filter.
Warning
Do not open induction unit!
High voltage!
