- 32 -
NOTE!
Remove or suspend springs symmetrically – the same number of springs must be
attached at each of the four sides after you have finished adjusting the height.
•
After adjusting the unit’s plate distribution height, check it in the manner described
above and remove an additional spring from each side as necessary.
•
Repeat this process until the unit is properly set up.
CAUTION!
If other plates are placed inside the rolling plate dispenser, check the height again
and replace or remove springs as necessary.
The unit is supplied with additional springs as replacements for those that have
worn out.
Capacity
•
The capacity listed for the rolling plate dispenser is approximate. The maximum
number of plates that can be stacked in one chamber is approx. 50.
•
The capacity of a chamber is dependent on the type and size of plates.
CAUTION!
Do not use plastic plates!
Put only round plates in the rolling plate dispenser!
•
Fill the chamber with the desires number of plates.
WARNING! Danger of injury!
Do not overload the device. Take care not to exceed the capacity given.
Overloading the device may cause it to tilt over and lead to serious bodily injury
and damage to the device!
•
Cover the chambers with the plastic covers provided with the device.
Activation
•
Connect the device to a single grounded outlet.
•
Turn the device on using the ON/OFF switch at the front of the device.
•
The green control light near the switch will come on to indicate that the device is
turned on.
