SURFACE PREPARATION SYSTEM OWNER’S MANUAL & PARTS BOOK
BARTELL MORRISON INC.
BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
25 INDUSTRIAL DRIVE, KEYPORT, NEW JERSEY, USA, 07735, 732-566-5400 FAX 732-566-5444
- 11 -
ASSEMBLY INSTRUCTIONS (Cont.)
c. Remove the four bolts (70) and lock washers (69)
from machine housing (104). Match up the holes
on the handle assembly to the machine housing
and insert the bolts (70) and the washers (69).
Tighten bolts corner-to-corner. Before final
tightening, place the machine on a flat surface to
ensure all wheels contact the surface.
2)
EDGER INSTALLATION
Make sure that the power source is disconnected;
unplug the electric unit; disconnect spark plug and
turn off fuel supply on gas unit; disconnect air supply
on air unit.
1. Tilt machine back onto handle (if your unit is
equipped with a Honda GX engine, unit must be
tilted forward or cylinders will be flooded with oil).
2. Remove cutter cage and retainer shaft.
3. Facing underside of machine, slide dummy
shaft (110) through outboard bearing on left side
(if engine is a Honda GX this will be on the right
side of the housing).
4. Slide retainer shaft (108) through edger cage.
The roll pin in the shaft head should fit into the
slot on the end plate of the cage.
5. Slide retainer shaft through the outboard
bearing and the dummy shaft.
6. Using a 15/16” socket or wrench tighten the
retainer shaft by turning counter clockwise.
7. Install edger housing (106) using the three bolts
supplied (107).
8. NOTE: Edger operation is not to be performed
with main SPS cage in place.
3)
STOP-SWITCH INSTALLATION
a. On gas powered models, feed the attached stop
wire under the bridge and through the circular
hole on the machine housing, from below
engine, up to attached terminal on the engine.
Secure it to the terminal by clamping with a pair
of pliers.
b. On electric models, attach bracket to the handle
with screws and lockwashers provided. Wiring
diagrams shown are for reference only: Figure
2a is for 220 volt and figure 2b is for 440 volt.
