CT250 FLOOR PLANER/SCARIFIER
OWNER’S MANUAL AND PARTS BOOK
5
OIPB
– C15009
destroy the shafts in the drum and the bearings of the machine.
Attention:
Never switch the motor of the planer on while the tools still touch the floor. Always lift
the machine and the tools clear from the floor and then switch the motor on.
Heavy dust can be avoided by connecting a dust collector to the dust port.
The vibration damped handle bar ensures an easier operation.
6.
Changing the drum
Attention:
Before any maintenance, the machine must be brought to a complete stand still. Always
disconnect the machine if it is an electric model.
-
Lift the machine with the lever so that the tools are well clear of the floor.
-
Unscrew the screws on the right side plate (M10, Key width 17 mm)
-
Carefully remove the side plate.
-
Take out the drum. Remove worn out tools. Check shafts and drums for wear and tear. If
necessary replace new tools on the drum.
-
Push drum on freshly greased shaft.
-
Reconnect side plate.
7.
Adjusting the drum
During the operation of the CT 250 floor planer or after a drum has been changed or replaced, the
drum shaft and the rear wheel axis can fall out of alignment. This results in an uneven track on the
floor. On one side the drum touches the floor before the other and therefore removes more surface
material on this side.
The two rear wheels are mounted on an eccentric shaft (see diagram).
