Inbetriebnahme
POLARIS PROFESSIONAL
POLARIS Panel PC Professional 15" bis 24"
EN 22/45
Technical data subject to change.
05/2020
Work steps
(1)
Insert the POLARIS into the cut-out in the enclosure.
(2)
From the back, place the reinforcement frame over the POLARIS.
(3)
Using the M4x12 (2) screws to fasten the mounting clamps (1) to the rear side of the
POLARIS and tighten to 1.37 Nm.
(4)
Tighten the clamping screw (3) of the mounting clamps (see illustration 7) to a torque
of 1.02 Nm.
Number of retaining claws
POLARIS 15″
12 Stück
POLARIS 19,1″
12 Stück
Always tighten the mounting clamps crosswise.
6.2.2
Installation as a System Solution in the Stainless Steel Enclosure "Exclusive II"
The POLARIS is available as a ready-made system solution in a stainless steel enclosure
e.g. "Exclusive II" for floor, wall or table mounting.
Selecting the location
COUTION
Pay attention to wall and ground condition!
A sufficiently stable wall (e.g. concrete or limestone) or floor (e.g. concrete) must
be selected for securing the load-bearing system.
The structural stability of the wall or floor must be able to bear 4 times the weight of
the POLARIS as system solution.
The support arm system must be assembled using suitable mounting materials
(M12) (e.g. dowels or stud bolts).
For POLARIS built into the enclosure door:
The open door must be supported and secured during the installation and servicing
phase. Otherwise the wall thickness specified may lead to the door sagging slightly when
open.
Summary of Contents for Polaris Remote 15"
Page 2: ......