Safety
Ex p relay
Power
Page 10 of 24
Rev. 0
20190910_Manual_Exp-Relais_Power_en.docx
Safety instructions for operation
Commissioning
Before commissioning, check that all components and documents are
available.
Inspection
Under EN/IEC 60079-17, the owner of electrical systems in hazardous
areas is obliged to have them checked by a qualified electrician to ensure
that they are in a proper condition.
Maintenance
For electrical systems, the relevant installation and operating regulations
must be observed (e.g. Directive 99/92/EC, Directive 2014/34/EUEC,
BetrSichV or the nationally applicable ordinances EN/IEC 60079-14 and
the DIN VDE 0100 series)!
Please observe the national waste disposal regulations for disposal.
Servicing
Regular servicing is not necessary if the device is operated correctly in
accordance with the installation instructions and ambient conditions.
BARTEC recommends annual servicing and inspection.
See Chapter “Maintenance and care”.
Repairs
Repairs on explosion-protected equipment may be done only by authorised
persons working in accordance with the latest developments in technology
and using original spare parts. The applicable provisions must be
observed.
Repairs must be carried out in accordance with EN / IEC 60079-19.
For Ex applications, only one device and one electronic module may be
used with corresponding Ex approval. Order the spare parts from your local
representative. The serial number can be found on the type plate of the
device, inside the enclosure.
