Barry-Wehmiller Thiele Technologies Streamfeeder Reliant 1500, Manual

Page: 19 / 72

13
R
elaint
1500 M
anual
Figure 12. Aligning Feeder with Insert Station
STEP 7:
Aligning and
Securing Feeder to
Insert Station
• Using your finger, turn the drive belt to advance a piece of your
material through the gate assembly area and under the feeder hold
down springs.
• Continue advancing the material until the trailing edge of material
fits between the feeder exit rollers (.25 in. to .5 in., or 6.4 mm to
12.7 mm of material).
• Carefully slide the feeder into the inserter station and center the
leading edge of your material under the inserter hold-down springs.
Ensure the front edge of the material is in-line with the front hopper
plate. See Figure 12.
• Once you are satisfied with the feeder alignment, press down on the
feeder top plate to secure the feeder suction cups to the inserter rear
deck plate.
T-handle
screw
S uctio n
c up